Cleaning/Installation Information

How to clean your Friction Floors

1. Begin by running clean water across the surface of the material. This removes any remaining lake water

​

2. Take your cleaning solution, lather the entire surface and scrub any hard stained areas.

​

3. Finally rinse your material thoroughly and cover appropriately

What to use

1. For typical cleaning and use a mix of dish soap and water will suffice for normal wear and tear. 

​

2. For any tough stains take a 50/50 mix of degreaser and water with a scrub brush to the area for the best results.

3. Avoid using a pressure washer within 8" of your material as it will shred through your kit.

​

4. Use a soft bristle brush for those tougher spots.

Prepping your surface for install

In order to prep your surface properly perform a thorough cleaning of the surfaces to be stuck and allow 12 hours for drying. Once fully dried in order to remove any left over grease and contaminants take acetone and a micro fiber cloth along the surface.

Installing your Friction Floor

1. Wash and prep your surface for install using your usual boat wash and allow to dry, then take acetone and a rag for final prep

​

2. Lay in your kit and align the center floor piece. Tac the corners when in position.

​

3. Working outwards align the design on the pieces surrounding the center and tac them down. Pull the backing 3 inches at a time and lay the piece.

​

4. To ensure no bubbles and proper adhesion run your hand along the entire surface and along the edge of each piece. 

​

5. Enjoy your new Floor!

Tips

1. Our Floors can be stretched and moved if small variations occur. If the piece is off by more than 1" contact one of our professionals with a picture of this issue.

​

2. In warm conditions be cautious when installing large logos as they are more prone to bubbles and wrinkles.